Gregory's Server|
176 comments
 @tubetime What you need is a Belkin F1DE083UK - adapts to a PS/2 keyboard fine, also cheap, but I had no luck with the 13W3 to VGA connector - needed a separate adapter for that. There's also the Raritan APSSUN which may work better but was too expensive to ship to the UK, but not a problem for you?   @tubetime you just need to port solaris 10 to it and then as long as the memory error is not in kernel memory the process would be killed and the location blacklisted. i bet it is this issue. basically the ZuluSCSI returns values for disk geometry that somehow confuses the Solaris partition tool. one solution is to use a real SCSI hard drive and then dd it over to the ZuluSCSI once the install is completed. https://github.com/ZuluSCSI/ZuluSCSI-firmware/discussions/122#discussioncomment-4418076  @tubetime damn, I wonder if it’s some kind of Mac-compatibility that’s breaking on SPARC? Many years ago I wrote a little tool called "scsi-ping" which gives you a working disktab entry for a SCSI disk. It's still out there somewhere.  @tubetime owo... i hope you saw @ncommander 's #Solaris livestreams... @tubetime Thanks for that! @tubetime Brings back happy memories. Should get my pizza box SparcStation out of the loft and see if it still works. Was running RH Linux last time it was fired up because I didn't have Sloaris installation media.  @tubetime I had to do this for my lunchbox machines (an IPX and an LX) But for my Sun Blade 100, I had to do a whole different thing to recover the IDPROM of the three machines, only the IPX got a modern IDPROM replacement. The others have CR2032s with holders hacked in. :o( (though not the Duct Tape Special you had!)  @tubetime Check the RAM. Bad modules can cause the "bad trap" error in Solaris on SPARC, although other things can, too.  @thejpster yes but these old workstations require 512 byte sectors for their cdroms in order to boot   @tubetime This inspires me - I have a VAXStation that uses a 3W3 video output (basically 13W3 without the digital pins) and it's impossible to find cables for it, but there are connectors for it around Do you do any termination or anything active on the board? I've made an RGB port adapter before and got pretty bad ringing, but it could definitely just be the monitor I used since I had no other way of testing. @nkizz no termination, that is done in the VGA monitor (75 ohm) @tubetime I need this board in my life. Twice. Maybe three. Where can I buy them?  @tubetime oh THAT might explain the ghosting in the screenshot i saw first 😱 @tubetime I haven't seen a 13W3 cable in a long time! That is quite a project!  @tubetime You only need the RGB if your display does sync-on-green. This is why I have a bunch of NEC LCD1990SX, they do sync-on-green and support a 1:1 aspect ratio in addition to stretching to fill the screen. @tubetime I have a few original Sun cables. Do you still need one? Free but P&P extra. I'm in the UK. |
couldn't find a Sun 13W3 cable adapter so I'm doing this to get to VGA.