Email or username:

Password:

Forgot your password?
Mark Jardine :misc_mtb:'s posts Post Back to profile
Mark Jardine :misc_mtb:

Print came out decently. Definitely a ton of supports were created under him which made it a bit of a pain to remove. But the tail and tusks made it without breaking. I’m probably going to try printing him upside down to see if it works out better.

#3dPrinting
1 February at 14:20 | Open on tapbots.social
12 comments
Simon B. Støvring
Tyler Stone :ca1:

@mark Send it over to @hotdogsladies for one of his faux finishes!

1 February at 14:23 | Open on sfba.social
Jay 🎃🕷️🦇👻
Dominic Hopton

@mark first pic makes me think of the not-xenomorh alien at the beginning of alien.

1 February at 14:38 | Open on mastodon.social
CM Skellington

@mark def some eldritch horror vibes when still on the supports.

1 February at 14:43 | Open on mastodon.online
Sean

@mark those first two pictures will haunt my dreams for years to come 😭😭

1 February at 15:03 | Open on mas.to
Ben Bieker

@mark where can we download the stl? 😀

1 February at 15:04 | Open on mastodon.try-to-hack.me
Mark Jardine :misc_mtb:

@ben I'l have to think about whether I want to release it to the public or not. But want to make sure it can be printed nice enough first.

1 February at 15:14 | Open on tapbots.social
Ben Bieker

@mark I could make a test print on my Bambu p1s 😉

1 February at 15:15 | Open on mastodon.try-to-hack.me
Dagaloni

@mark holy 😬 that first pic looked like a horror version where the elephant is grabbed by many arms into the earth!

1 February at 15:05 | Open on mastodon.social
Filip Radelic

@mark try increasing overhang threshold first under print settings/ support material. Try increments of 5 and see how it slices. Could also play with manual support blockers, eyes definitely don’t look like they need them.

1 February at 15:18 | Open on mastodon.social
Go Up