Gregory's ServerI'd feel bad for the CPU but it's a Celeron D. lol.
|
25 comments
@tubetime https://www.eevblog.com/forum/testgear/agilentkeysight-infiniium-mso9000-series-motherboard-repairupgrade/ Do these logic analyzers also run PCI-E over a SATA cable to the acquisition board?  @humulus regular PCI to an interface card, and the card has a ribbon cable going to the backplane. so I pulled the MOSFET and tried to power it up, and it works!? I'll probably still find a replacement MOSFET to avoid excess stress on the other phases. @tubetime did you need to swap the cpu, or did it survive the overvoltage? i'm really hoping that a simple FET replacement will get this thing going reliably. the motherboard is technically off the shelf (Adlink M-880-Nitro) but people want lots of money for them. @tubetime seems a wonder it didn't die with that mosfet but maybe CPUs have features against mosfet latch up or the pmic detects it and shuts off the MOSFETs arrived. who knows if this will work... well it boots but now the frame isn't detected. so there's something wrong with the PCI card, the cable, or the backplane itself. BTW, this is why the CPU didn't fry--the multiphase buck controller (the ADP3168) has crowbar protection in case of a shorted high-side MOSFET! so the sequence of events in this case went: it would be nice to have a second probe cable. this is the less common 60-pin cable, not the stubbier 50-pin one used on the 1650 series. they're super hard to find for some reason. thinking about the failure a bit more. here's the precise cause with a nice diagram. a high-side MOSFET failed in a short circuit, which would put 12V on the sensitive CPU core rail. however, the controller chip detected the overvoltage and turned on all the low side FETs (circled in green).  @tubetime Do you know whe there are only three high-side FETs but six on the low side? @tubetime ah so the pmic did protect the CPU, as expected, nice to see that even in this era such protections where already in placw, can't even begin to imagine the complicity of a pmic powering a modern Intel or AMD CPU.    @tubetime Have you considered upgrading the CPU? Looks like there are a few that are compatible with the socket and wouldn't increase the TDP. |
@tubetime i mean we all need the D