Email or username:

Password:

Forgot your password?
Bad Diode

so, say that I wanted to use the output of a gb/gba link cable to send a CV clock signal. I believe the GB link cable can output +5V and the GBA 3.5V? Would this be enough for a clock signal to be interpreted correctly?

#gbadev

2 comments
zuggamasta

@bd if you actually want to use it in eurorack modular, the signal could be boosted before usage. Not all clocks are the same tho. Done modules want square waves, some short triggers and the rine resolutions vary, too.
But generally speaking: yes this should be workable (from my experience as USER, not software nor hardware dev)

Bad Diode

@zuggamasta thanks this is already useful I guess if it's module dependent I would need to check the requirements for individual modules. I still need to figure out how to control the serial output from the software but it is encouraging! Now I need to figure out a way of sending/receiving cv voltages from the computer to test things out... maybe I can achieve that with gpio?

Go Up