Gregory's Serverdid a little math and it looks like there is a 2 sysclk delay plus the input propagation delay and output propagation delay. the prop delays total about 8.8ns.
|
9 comments
 anyway i can overclock to 300MHz sysclk, and now the minimum delay is 15ns. that is 2 cycles of 3.3ns plus 8.4ns propagation through the input and output. argh, i forgot that i put 20MHz BW on the two input channels. anyway, this looks better, the rise time is super fast and the propagation delay is 13.7ns. all right, i'm going to run another 24h aging experiment with 5V on the unpowered pin. let's see how it does. i'll do the measurements at 150MHz. my suspicion is that hot carrier injection could increase the propagation delay of the input, but we shall see. i could dig into this some more, but for now, it looks like the RP2350 is 5V tolerant. i didn't see any evidence of HCI or metal migration. these aren't exhaustive tests since i didn't do them over the full supply voltage and temperature range, so i wouldn't use it for 5V tolerance in a commercial project, but this should be fine for hobby projects.  @tubetime Sorry if you already said it and I lost the info, but did you test only on FT pins or also no non FT pins?  @tubetime now do the RP2040, that one is a bit more of an open question 😅 |
hmm so i understand why there is 1 sysclk delay because it takes a cycle to go from the WAIT instruction to the SET instruction. but why 2 sysclk delays?