Email or username:

Password:

Forgot your password?
Top-level
Ken Shirriff

The display is constructed as a matrix. One line selects the digits and one line selects the value of that digit. On the back, each digit has a diode matrix card.

Ten small circuit boards on the back of the display. Each holds ten striped diodes. Horizontal wires run between the boards, suspended in the air. A bundle of yellow wires connects the boards to the rest of the system.
3 comments
Ken Shirriff

The system was built by CDC in the 1970s, probably for aerospace navigation, but I haven't been able to find any details.

My previous thread on this system: oldbytes.space/@kenshirriff/11

Sorvall

@kenshirriff it’s aerospace and It looks military. But I’m fairly sure that it’s not navigation. Military aircraft from the 50’s would either use TACAN, a beacon system or INS which means it would need to be hooked up to a gyroscope.

It could be part of an early form of computer bombing system for some kind of primitive CCRP release system. But even then it’s missing things that a bomb system would have like inputs for measurements like drag factors on bomb types.

Things like T/A (Target Angle), and G/T (Ground Target?) make it look like it was at least part of some kind of targeting system.

@kenshirriff it’s aerospace and It looks military. But I’m fairly sure that it’s not navigation. Military aircraft from the 50’s would either use TACAN, a beacon system or INS which means it would need to be hooked up to a gyroscope.

It could be part of an early form of computer bombing system for some kind of primitive CCRP release system. But even then it’s missing things that a bomb system would have like inputs for measurements like drag factors on bomb types.

spmatich :blobcoffee:

@kenshirriff do you know if the surface mount boards were wave soldered or would soldering have been done by hand?

Go Up