Email or username:

Password:

Forgot your password?
avp's posts Post Back to profile
Top-level
M4x

@avp That looks nice. What are you using as the actual filter (the green part I assume)?

This is my dust filter.

#3dprinting

Picture of a 3D-printer (homemade MKC MK2 v1.0) Detail shot of one outer side including a kind of stick where the filament roll sits on (transparent PETG). A green arrow is pointing towards the white dust filter where the filaments passes through (I think it's something like pressed wool)
29 February at 14:37 | Wall-to-wall | Open on chaos.social
1 comment
avp

@M4x Hi! I'm using a cutout pieces of a kitchen sponge. The filament is placed between two sponges inside the 3D-printed cylinder as you can see on the attached photo.
29 February at 19:22 | Open on fosstodon.org
Go Up